BETAFPV F4 FC 1ST Brushed Flight Controller DSMX Receiver ESC OSD Smart Audio for Tiny Whoop FPV Micro Racing Drone
Feel free to take note the binding procedure is various from in the past, there is no bind switch on it, simply set in betaflight and then energy on, switch on the radio and choose bind mode, additional details checking below:
Central Processing Unit: STM32F411CEU6
ESC: All FETs are ranked at 30A optimum. Help 6x15mm/7x20mm/8x20mm/ 8.5 x20mm etc electric motors.
Dimension: 26mm x 26mm, entirely suitable along with the Inductrix quad framework and installing pattern
Firmware variation: Betaflight MATEKF411RX 3.5.0
OSD: Built-in BetaFlight OSD (STM32 commands OSD potato chip over SPI in DMA mode)
Receiver: DSM2/DSMX (DSMX in nonpayment)
Power Cable: 55mm, along with JST-PH 2.0 connector, AKA PowerWhoop connector
Weight: 3.8 g
1 * F4 DSMX Brushed FC (55mm PH-JST 2.0 power line fastened)
4 * M1.2 x4mm screws (Fit for assets Inductrix framework)
4 * M1.4 x5mm screws (Fit for Beta75 etc 75mm framework)
4 * Anti-vibration ruber restraints
1 * 55mm PH-JST 1.25 power line pigtail
BETAFPV F4 FC 1S Brushed Flight Controller Integrated DSMX receiver and OSD. NOT compatible with Spektrum DXe radio transmitter and OrangeRX RF module. For some Spektrum radio transmitter like DX6i/DX6e etc, the DSMX receiver may have a horrible range with your radio transmitter, please change the mode to DSM2 (DSMX in default).
The binding procedure is different from before, there is no bind button on it, just set in betaflight and then power on, more details checking here: https://betafpv.freshdesk.com/support/solutions/articles/27000021366-how-to-bind-your-radio-transmitter-brushed-fc-board
The F4 brushed FC board bring a new era in FPV whoop technology. Improved on 3 points: STM32F411 100MHz high performance MCU, 30A lower resistance MOSFETs and polar reversed protection. All of these is backed by the same reliability and warranty of all BETAFPV FC boards.
Fully programmable through Betaflight, using the onboard USB port, tune all the parameters, PID's, and rates to your perfect settings.
The flight controller board comes pre-flashed with Betaflight firmware, and pre-soldered 55mm power cable pigtail with JST-PH 2.0 connector, AKA PowerWhoop connector.